While cleaning your car at home might save you money by avoiding the cost of a professional vehicle wash, it can also use a lot more water than necessary. A single vehicle requires an astonishing 40 to 140 gallons of water for the typical home car wash. Keeping a clean automobile might be difficult in areas where there is a drought or if water conservation efforts are being made. Fortunately, there are several techniques you may utilize to save water on vehicle wash.
Here are some suggestions to help you conserve water when washing your two- or four-wheeled vehicles:
1. Before drenching the car with water, dust it off. Sometimes all your automobile needs to seem clean is a simple dust-off. In order to lessen the quantity of dust that gets on your automobile, keep it covered.
The procedure of cleaning an automobile is rather easy. In order to avoid surplus water from evaporating and to conserve water, try to choose a cool, shaded area. Ideal locations are those that are close to water sources so that you don’t have to transport water too far. If the location is on a lawn, that’s even better because water run-off will water the grass.
So you’ll save water and avoid having to water the lawn later. To wash the entire automobile, just three tiny buckets of water are required. Give the car a quick rinse to remove contaminants with the first small bucket and a sponge or soft cloth. Pour the remaining water if you have any extra.
2. Use a bucket rather than a hose that sprays water continuously. If you’re using a hose, get one with a spray handle that turns the nozzle off when you walk away. In accordance with the Department of Environment in Maryland, USA, in such a setup, a 100-gallon vehicle wash only uses 30 gallons. If utilized properly, pressurized flow is more effective.
3. Professional vehicle washes and drive-in car washes frequently include water recycling systems that significantly cut down on the quantity of water consumed. Pressurized water is also used by them.
4. In areas where there is a shortage of water, steam cleaning and “dry wash” or “waterless” cleaning methods are becoming more and more common. In their service facilities, automakers including Maruti, Hyundai, Nissan, and a few others have installed such environmentally friendly vehicle washing technology. To leave a shining surface behind, they utilize a kind of foam that is sprayed on the automobile and then removed with a microfiber cloth. Nissan asserts that their system uses 45% less water than a conventional car wash. According to Maruti, this procedure takes about 20 minutes every wash, vs 45 minutes for a normal approach.
5. When washing your car at home, attempt to do it next to a garden so that the runoff water may be absorbed and put to good use. Be careful while choosing shampoos, it has to be biodegradable for cleansing. Instead of using fresh water to wash automobiles, the Bangalore Water and Sewerage Board suggests using treated wastewater to save water on vehicle wash.
6. Use a pail of soapy water to clean automobiles, The conventional solution is soap and water. Read the label carefully if you require a particular cleaning product for cars, and make sure you choose a non-toxic, biodegradable detergent. Anything with the words Poison, Harmful, or Danger on it should not be used. While washing a car, be sure to switch off the flowing water.
One can also use car shampoos and follow these steps- fill the bucket with a modest amount of the best car foam wash shampoo in India (not dish soap). When your sponge and soapy water were at their cleanest, it is an excellent decision to start with the windows. Then, start washing the automobile from the roof, going over each component one at a time. Conserve water while rinsing and exercise caution when using excessive amounts of detergent since more water will be required to remove the soap. As you wash the automobile, try to rinse each area to prevent the suds from drying on the surface.
7. Think about using a professional vehicle wash, Take your car to a public spray booth or car wash if you can’t wash it in a spot that drains to the grass or gravel. A sanitary sewer that connects to a properly constructed car wash transports the filthy water to a wastewater treatment facility.
Conclusion:
In conclusion, using a waterless car wash technique is a practical approach to conserve water while maintaining the cleanliness and shine of your vehicle. You may greatly minimize your water usage and help to preserve this priceless resource by using cutting-edge waterless vehicle wash products and practices.
